Product Info > DURA-SEAL Water Spot Remover
DURA-SEAL Water Spot Remover
Tap water being left to dry on your car will cause water spots. Nothing that can stop that unfortunately.
The method of choice in the past was to polish the car to remove these hard to remove spots, which was a lot of hard work and also meant grinding a layer of the top coat off.Now with Dura-Seal Water Spot Remover it is an easy job without the need for polishing at all.
Only apply to paintwork that is cool to touch.
Directions for use
- First test the surface to be cleaned. The product may not be suitable on all surfaces, plastics and glass in particular. Do not leave Dura-Seal Water Spot Remover or the application cloth on any surface longer then as per instructions.
- Make sure that the area where water spots are to be removed is clean and free of sand and dust etc.We recommend you use Dura-Seal Q-Clean to first clean the area.
- Apply a small amount of the product to a cloth or mitt and then wipe this onto the panel, leave it for about 10 seconds.
- Then rinse with water and dry the panel, proceed to the next panel/area. When all spots are removed we recommend that you rinse the all cleaned panels once more and towel or chamois dry.
For best results finish with Dura-Seal Q-Clean.
